Heat Exchange & E-Drive Cooling

comemso launches Easy Chester Micro for AC charger and ISO 15118-2 testing

The portable tester combines AC charging checks, ISO 15118-2 communication verification and optional safety tests in a single 5.4 kg case.

Details

  • PublishedNovember 9, 2026
  • Reading5 min
  • SectionHeat Exchange & E-Drive Cooling
  • Views2

In this article

  1. Vehicle simulation and communication checks
  2. AFIR context and product limits
  3. Optional safety and fault tests
A rugged portable AC charger tester with a touchscreen and Type 2 connector sits beside a wall box on a service bench, with test leads ready for connection.

German test-equipment manufacturer comemso has launched the Easy Chester Micro, a portable tester for AC wall boxes and charging stations. The unit combines charging and communication tests with optional safety tests, packaging an installation tester and adapter box in one case weighing 5.4 kg. The case is rated IP 66 when closed. The device is aimed at field diagnostics and commissioning work.

comemso positions the device for electricians and service teams working on commissioning, maintenance, periodic inspection and post-repair checks. A 10.1-inch touchscreen guides users through each step, and the tester does not require a laptop or a customer vehicle to run its checks.

Vehicle simulation and communication checks

The Easy Chester Micro simulates a vehicle according to IEC 61851-1 and SAE J1772. Depending on configuration, it connects through a Type 1 or Type 2 AC inlet and measures Control Pilot voltage, PWM duty cycle and Proximity Pilot values. The measurements are taken through that inlet, so the tester works at the interface an EV would use.

If a charging station supports ISO 15118-2, the tester establishes that communication without an external protocol converter. Charging is authorized through External Identification Means such as an RFID card or an app. In addition, an ISO 15118-2 test checks the station’s powerline communication (PLC) chip and the PLC link to the vehicle. The test report records the Signal Level Attenuation Characterization (SLAC) connection setup, its attenuation value and the station’s PLC MAC address.

AFIR context and product limits

comemso notes that, since January 8, 2026, the EU’s Alternative Fuels Infrastructure Regulation has required new or renovated public charging points to comply with EN ISO 15118-1 to -5. The company says the Easy Chester Micro can support ISO 15118-2 testing in that context, but it does not replace a full AFIR conformity assessment.

The current device also has clear boundaries. Support for ISO 15118-20 is planned for the first quarter of 2027, and TLS-secured charging sessions are not supported. For DC stations, comemso offers a separate product, the Easy Chester Ultimate.

Optional safety and fault tests

Optional safety tests to VDE and IEC standards are available for the grid and vehicle sides. They measure insulation resistance from 250 V to 1,000 V and protective-conductor resistance at 200 mA or 25 A. The tester can also check residual-current devices at 6 mA to 300 mA.

Optional fault simulations verify whether a station stops charging after a protective-conductor break, a CP or PP short circuit, or a PP break. According to Kiriakos Athanasas, CEO of comemso, the Easy Chester Micro shows technicians what to connect and what to do next directly on the touchscreen.