Chargebyte has launched the Charge Control Y, a charging controller designed for megawatt charging stations that serve electric heavy-duty vehicles. The Leipzig-based company positions the unit for logistics centres, truck depots, ports and motorway service areas, and says it can be used both to equip new charging stations and to retrofit existing installations.
A large part of the development effort went into resistance to interference and to harsh environmental conditions. The vehicle interfaces carry reinforced galvanic isolation in accordance with IEC 60664-1, and the controller is built to withstand overvoltages of up to 1,500 volts DC as well as rated impulse voltages of up to 4 kV. According to Chargebyte, a high-voltage fault in the charging cable leaves downstream control units, the backend and connected components isolated.
Sealed housing and a wide operating window
The enclosure is protected to IP65 against dust and jet water, and is specified for ambient temperatures from -40 to +70 degrees Celsius and humidity of up to 95 per cent. All cables connect through watertight M12 connectors. Those ratings are aimed at depot, port and roadside installations, where equipment stands outdoors and has to keep operating through weather swings as well as high-voltage faults.
Inside the device, two separate computing units work in tandem. A primary computer manages regular charging and communication, while a secondary processor serves exclusively as a safety monitor. It continuously oversees emergency shutdowns and up to four temperature sensors located in the cooling system, the charging plug and the power electronics. Where there is a risk of overheating, the system automatically reduces charging power or shuts the station down.
Protocol support, safety rating and remote updates
On the software side, the controller supports the ISO 15118-20 protocol for modern charging communication, including Plug & Charge. The integrated safety monitoring meets the SIL 1 industrial standard under IEC 61508, and a TPM hardware chip provides protection against cyberattacks.
Chargebyte builds on the open-source EVerest system, which allows charging station manufacturers to adapt and develop the software without being tied to a single provider. Operational and security software updates can also be installed remotely, which the company says reduces service effort at sites such as ports and motorway service areas.
The Charge Control Y is developed and manufactured in Germany and is available immediately, according to Chargebyte.
